What do you need to hook up subs and amp, instructables
The sub will use its built-in crossover aka "low pass" filter to determine the upper limit of the frequencies produced by the subwoofer. I have checked all my fuses and have even opened up the amp case to see if i can figure out whats wrong but nothing looks ab normal.
Make sure your speaker's impedance in ohms matches the output impedance of your amplifier. What I have done is wired the speaker output, into the rear speakers. Make sure you're connecting the left and right output speaker wires into their corresponding left and right speakers.
It is Flirt dating site reviews fact of life that under the carpets of most motor cars is moisture, brought in from the outside atmosphere and trapped by the carpet. Connect the subwoofer output to the amplifier input.
If you have a aftermarket already installed or to be installed look at the instructions that came with it if you can put in a sub it will show you how to wire it, plus the ones with the amp you will be fine the hardest part is runing the wires, and the second hardest part is making sure the posative and negative on the amp are right other than that it should just be plug and play as it says above.
Rms stands for square root of the average of square. Now, connect your amplifiers to their power source, check your wiring; then turn it on. You have two basic options: Connect your speaker wires to these outputs -- one into each output.
How to hook up a subwoofer to a stereo system Hint: Amplifier power measuremnt is watt rms. Stereo receivers, pre-amps, and integrated amplifiers rarely have subwoofer output jacks or offer bass-management options. When purchasing either form of amplification, look for an amp that accepts high-level signals.
Because the subwoofer is working mostly on the bass the low tonesit doesn't require as much directional pushing as speakers do.
From what I have seen happen is that the subs work in 2 main ways that I know of.
I have to make one comment, though, which anyone installing powerful subwoofers into an automobile needs to be aware of. You don't necessarily need a receiver with subwoofer output jacks. Most amplifiers will have outputs for at least two speakers.
The jack on the amplifier may even be labeled "subwoofer output," just to make things easy for you. The nerdling 6 years ago Reply what's with your profile pic? A watt rms output should never be inputed in a speaker with less thant watt mximum input.
If you follow this guideline, you won't blow up you speakers and improve sound output quality! Subwoofers can be large speakers that are usually housed in speaker enclosures installed in the trunk of the car. Most, but not all, subwoofers have these inputs; they get connected using speaker cables to the same speaker output jacks on your receiver or amplifier that are also hooked up to your speakers.
That means you have to double up the connections on the receiver or amplifier see photo below that illustrates that connection method. To do this, you'll need your subwoofer, an amplifier, at least one set of RCA cables these are the red, white, and yellow jacks on a single cablespeakersand speaker wires.
So instead of using those connections, we'll use the subwoofer's speaker-level, aka "high-level," inputs. I usually spend at least a few hours listening with lots of different types of music to fine-tune the crossover and subwoofer volume settings. For more information read this post on how to set up a subwoofer.
All my other speakers work fine. This converter can then be connected directly to your amplifier's line level What do you need to hook up subs and amp.