Coil hook up design guide, coil return line options
The Eng-Tips staff will check this out and take appropriate action. Guide handles allow the lifter to be easily maneuvered.
Email Newsletter Signup
Waramanga Mechanical 18 Jan 12 If it is a hot fluid, more gases might be stripped from solution with the coil throttling on the inlet side.
Also painted safety yellow and clearly marked on both sides with rated capacity to conform to OSHA standards.
The combined widths of the coils are equal to the maximum coil width of the lifter. Counterweight balances and hangs the lifter, both empty and loaded. BronYrAur Mechanical 30 Dec 11 This could be detrimental to the performance of the coil regardless of the position of the control valve.
Cancel Thank you for helping keep Eng-Tips Forums free from inappropriate posts. Lower dissolved oxygen extends equipment life. Red Flag This Post Please let us know here why this post is inappropriate.
Integrated lifting bail saves headroom and minimizes inspection normally associated with welded lifting bails. If it is a cold system, it is always better to have less thermal breaks on the colder side e.
Integral lift loop reduces headroom and requires less maintenance than conventional welded lift loops. Optional urethane bumpers can be added to provide additional protection. Radius in corners reduces stress concentrations in critical areas without interfering with the object being lifted.
A couple of old-timers have always told me that it doesn't matter what side the control valve is on, however, I still prefer to keep it on the downstream side to keep the coil flooded.
The return side installation reduces sweating on the electronic actuator, which is more prone to failure when wet. During a water's travel through a coil, the piping becomes smaller e.
Maneuvering coils within narrow clearances can be done easily with ELT, Inc.
This reduces pressure of the fluid. Arc top better suits the contour of the ID of a coil which prevents sharp edges from damaging the product. If it is a hot system, some manufacturers have temperature limiations on the actuators.
The Slit Coil C-Hook has a longer lift arm allowing the unit to carry multiple coils equal in size to the maximum coil width. I found the following information on the www. High strength alloy steel reduces the physical size of the lift arm allowing movement into confined areas for direct crane loading and unloading.
At The Terminal The preferred location for manual or automatic balancing valves is the return side of the coil, as shown in the detail in the Balancing Valve on Coil Return diagram above. ChasBean1 Mechanical 4 Jan 12 Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.
But this does not mean the installation will not work correctly, and performance-wise you might not see an issue immediately: With a control valve on the return side, the water is at a higher pressure through the coil, reducing offgas, thereby lowering dissolved oxygen content.
Select your country or region
Lifting coils of sheet steel into a production line as quickly and safely as possible will ensure overall production efficiency and safety. Effective Coil Handling will address lifting efficiency and varied production needs. Does anyone know where to get that guide?
- Dating and marriage tips
- Gamer dating sites us
- Who discovered the oldest human footprints dating back 117 000
- How to see if your spouse is on a dating site
- The head and the heart members dating
- Marriage not dating viki
- Best online dating sites philippines
- Best free online dating site in usa
- Gay jewish dating new york
- Local chicago dating services
- Aztec human sacrifice essays
- Millennials dating apps
- Dating sites victoria bc
- Instrument hook up material